TheHaflinger.com

The seller said he got the PTO fitted to run a generator but never did.

"l don't intend to lose money on this vehicle" .....if only that were true for all my previous vehicles! :) I just sent the seller a message asking about the PTO and what if anything it drives. I have a PTO on mine too but no lever or floor cut out (someone did a gearbox swap in the past)....

Thanks John,

So I think I have simply got my seat belt brackets flipped the wrong way. Doh! Retractors should fit as per your photo then. Thanks!

seatbelt bracket by pureredcordial, on Flickr

--matt

Hi all, I want to fit 3 point seat belts to my haflinger. I can't see how a retractor belt will clear the seat frames so looking at adjustable non-retractor belts. Could anyone measure the length of the lap/sash strap so I order the correct one? **SHORT 1865mm **STD 2165mm, **LARGE 2565mm, **XLARGE ...

What about if you make the documentation forum only available to members who have donated?
Also other forums also have different "search" allowances based on membership. eg 1 search per minute for guests, 1 per 10 seconds for members.

Yellow button pressed.

Cheers

Here's another photo I took showing the PTO lever. The dash, ignition key all match. Cheers

IMG_3449 by pureredcordial, on Flickr

That's my photo I emailed to Constantin. The original ebay winner was definitely in Australia - I did email him once not long after the auction.

cheers

I've stared at those gumtree photos and ones I took in 2008 in Bungendore of a haflinger that was meant to be an ex-Action Buses street sweeper (Canberra's bus company). I obviously didn't win that auction and I recall it went to the north coast of NSW. It's been tidied up a bit since my photos but ...

Did you buy the one on ebay from Queensland?

Mine came up pretty well in the end! I used some metal polish on the chrome bezel while it was apart. Go easy with the polishing - the bezel is pretty flimsy when not attached. https://c5.staticflickr.com/8/7207/27540122780_7bf37f8236_c.jpg IMG_20160618_174718 by pureredcordial , on Flickr --matt

Agree! Once I got a little screw driver in there, I held it still and rotated the gauge around face down on some old carpet. Did that quite a few times to open it up enough to get the glass out.... and left no finger prints on the inside

Thanks. Round and round and round with a small screwdriver worked fine.

I'll try buffing some more first - in my case I think the glass is pitted.

An old thread...but were you successful in prying off and re-using the bezel ring? I want to swap the glass between two speedos I have.

thanks

Sure. If my is back together. In the middle of painting if it stops raining.

Jim, portals will win I'm sure!

Jeep...as they say Just Empty Every Pocket

...and amusing myself with tyre comparisons

IMG_20160523_203927 by pureredcordial, on Flickr

I can squeeze my LWB into an 8x5.....just!

IMG_3508 by pureredcordial, on Flickr

Restorable. Bit of rust on the inside. Looks ok from the outside - there is a pinhole as pictured. There is only 1 spring. https://farm8.staticflickr.com/7306/27025884205_7c5d59b66c_m.jpg IMG_20160515_144752 by pureredcordial , on Flickr More at https://www.flickr.com/gp/pureredcordial/UMV993 Let me...