inlet / exhaust manifold
Posted: Wed Jun 21, 2017 8:25 am
The only thing I did not replace on the rebuild was the exhaust manifold, so when a hole appeared I thought I had better have a stainless steel one made. The pre heat on the inlet manifold had been repaired by someone earlier as you can see the pipes were not level with the inlet pipes, so I also had them both replaced with stainless. It took a few visits to the welder, to get all the angles to match up, he did it all freehand from the existing manifold, the pre heat pipe alteration was a after thought. it now sound a lot better and starts as soon as I turn the key.
Dave
Dave