Handbrake cable parts - Help!
Posted: Tue Nov 26, 2013 3:12 pm
I have made a mistake with failing to keep a proper record of how the parts that go to form the end of the handbrake cable to together - can anyone help me?
Bear in mind that this is an Early Series 1 Haflinger, and that there are no S shaped Returning Springs (7-06 #32, 700.134.0861) helping to release the handbrake when the handbrake lever is lowered (i.e. off).
I know that the Handbrake Cable passes through a Tubular Bracket which is welded on to the half axle.
I am fairly sure that the long Rubber Grommet sits inside the Tubular Bracket, having been pushed up into it from the rear.
But where should I put the Long Spring and (what I have called) the "End Piece"? The only photo that I have from before I stripped it all down shows no Long Spring or "End Piece" at all. I may have added them after I took that photo a couple of years ago, but can't recall.
The diameter of the Long Spring is slightly smaller than the Tubular Bracket, and so it could go up inside the Tubular Bracket, but if so I can't work out what to do with the Long Rubber Grommet, nor how to stop the End Piece from falling off.
TIA !!!
Bear in mind that this is an Early Series 1 Haflinger, and that there are no S shaped Returning Springs (7-06 #32, 700.134.0861) helping to release the handbrake when the handbrake lever is lowered (i.e. off).
I know that the Handbrake Cable passes through a Tubular Bracket which is welded on to the half axle.
I am fairly sure that the long Rubber Grommet sits inside the Tubular Bracket, having been pushed up into it from the rear.
But where should I put the Long Spring and (what I have called) the "End Piece"? The only photo that I have from before I stripped it all down shows no Long Spring or "End Piece" at all. I may have added them after I took that photo a couple of years ago, but can't recall.
The diameter of the Long Spring is slightly smaller than the Tubular Bracket, and so it could go up inside the Tubular Bracket, but if so I can't work out what to do with the Long Rubber Grommet, nor how to stop the End Piece from falling off.
TIA !!!