Handbrake return spring

Post Reply
User avatar
Julian B
Posts: 872
Joined: Sun Dec 30, 2012 4:07 pm
Location: W Sussex, UK

Handbrake return spring

Post by Julian B »

Can anyone confirm whether the handbrake return spring (7-06, #24 & #25) shown in the attached photo is correctly "seated"? On my other Haflinger the front arm of the spring is NOT located within the notch cast into the hub - unlike in this photo. Which begs the question ... which is correct!

Thanks in advance,

Julian
Attachments
2013-04-10_17.39.30_2-2.jpg
2013-04-10_17.39.30_2-2.jpg (304.91 KiB) Viewed 842 times
Julian B
W Sussex, UK

| '62 Early Series I SWB | '72 Series II LWB |
| '56 Citroën Traction Avant |
pathfinder700ap
Posts: 201
Joined: Sun Dec 30, 2012 4:38 pm
Location: Graz, Austria

Re: Handbrake return spring

Post by pathfinder700ap »

Hi Julian,

the arm should go into the notch - it's correct on your picture.


Kind regards,
Constantin
User avatar
Julian B
Posts: 872
Joined: Sun Dec 30, 2012 4:07 pm
Location: W Sussex, UK

Re: Handbrake return spring

Post by Julian B »

Many thanks, Constantin; I'll sort this on out my '62 Haflinger tomorrow!
Julian B
W Sussex, UK

| '62 Early Series I SWB | '72 Series II LWB |
| '56 Citroën Traction Avant |
Post Reply