So on the Swiss '63 I have, the front CV bellows are rotten and in dire need of replacement, along with the CV needing flushing, lube and assessing to see if it's worth keeping or needs replacing.
I see that the later models have a completely sealed metal housing, instead of the rubber bellows.
Can I upgrade to the later version? Will the lengths, widths, bearing and seal surfaces and splines match?
CV joints....question about the older and newer...
CV joints....question about the older and newer...
Swiss 1963 700AP, Weber 32ICS carb, electric fuel pump, Black Diamond XTR 25x8x12 tires, Pertronix, civilian ignition and regulator system conversion, extra fuel filters, 4 point belts, NATO 3 color camouflage, Cobra CB radio, battery cut off switch
Re: CV joints....question about the older and newer...
As far as I know, they are interchangeable. Haflingertechnik have a new version, but it is expensive.
John
John
Haflinger 703AP LWB 1973 - (Once owned by Lady Sutherland & Sons.) Now called "Lurch" !
Have you hit the "DONATE" button at the bottom of the page after reading this post? Many thanks if you have!!
Have you hit the "DONATE" button at the bottom of the page after reading this post? Many thanks if you have!!
Re: CV joints....question about the older and newer...
Look on the Haflinger technik site and there are useful technical bulletins on this issue.
http://www.haflingertechnik.com/ftp/tec ... dfs/11.pdf
http://www.haflingertechnik.com/ftp/tec ... pdfs/4.pdf
http://www.haflingertechnik.com/ftp/tec ... dfs/11.pdf
http://www.haflingertechnik.com/ftp/tec ... pdfs/4.pdf
Best Regards
Stuart
Northampton
Stuart
Northampton