Haflinger windscreen supports (pair) needed.
- cascade.king
- Posts: 188
- Joined: Sat May 11, 2013 6:54 pm
- Location: Vermont, USA
Haflinger windscreen supports (pair) needed.
My Hafi (Pathfinder) didn't come with them, and before I explore making (bodging) my own, I figured I'd look for a pair.
Anyone have a set, or leads as to where to get some?
Anyone have a set, or leads as to where to get some?
Mike
1971 North American 700AP Haflinger Pathfinder
1971 North American 700AP Haflinger Pathfinder
Re: Haflinger windscreen supports (pair) needed.
I am after a pair of the same as I expect are a number of members. I know a number of companies in the UK who are very good at making hood sticks, perhaps we could do a survey to judge everyone's needs and make a bulk order.
Cheers
Doug Hart
1972 AP 700
Doug Hart
1972 AP 700
Re: Haflinger windscreen supports (pair) needed.
I might have a couple , but postage would cost more than making them
kerry
kerry
ex Tasmanian Haflinger agent .
1984 G Wagen 300GD auto
1984 G Wagen 300GD auto
Re: Haflinger windscreen supports (pair) needed.k
True, perhaps you could let me have the dimensions.
Cheers
Doug Hart
1972 AP 700
Doug Hart
1972 AP 700
Re: Haflinger windscreen supports (pair) needed.
can do mate , it may take me a few days .
also I can send photos with a tape measure alongside .
but to do this I will need an email address .
it is the only way I can deal with photos .
kerry
also I can send photos with a tape measure alongside .
but to do this I will need an email address .
it is the only way I can deal with photos .
kerry
ex Tasmanian Haflinger agent .
1984 G Wagen 300GD auto
1984 G Wagen 300GD auto
Re: Haflinger windscreen supports (pair) needed.
I should be able to give you some measurements very soon , I have been busy .
if you want photos , I still need an email to send them to .
kerry
if you want photos , I still need an email to send them to .
kerry
ex Tasmanian Haflinger agent .
1984 G Wagen 300GD auto
1984 G Wagen 300GD auto
- AustHaflinger
- Posts: 2475
- Joined: Sun Jan 06, 2013 1:27 am
- Location: Canberra Australia
Re: Haflinger windscreen supports (pair) needed.
Just so happens my side tubes are off the car so here are some pics.
Overall - zoom in to see scale - but there are a mm or two just under 79cm long
The roll bar end
The windscreen end - note the bar is lying flat and end in turned in and twisted to account for the slope of the windscreen.
The front of the rail against the windscreen
The rear of the rail
If you cannot see measurements you need let me know. You might need to save and zoom but it is still a but hard to see.
I would get some tube and cut it longer than needed and make the roll bar end first and then using the vehicle windscreen as the guide band the front end to fit - needs to be tuned in 90 degrees but also twisted to take into account the slope of the screen - basically the bottom of the edge of the bar needs to be a few mm longer than the top of the bar.
However I would have thought places like Haflinger Technik would have them
Overall - zoom in to see scale - but there are a mm or two just under 79cm long
The roll bar end
The windscreen end - note the bar is lying flat and end in turned in and twisted to account for the slope of the windscreen.
The front of the rail against the windscreen
The rear of the rail
If you cannot see measurements you need let me know. You might need to save and zoom but it is still a but hard to see.
I would get some tube and cut it longer than needed and make the roll bar end first and then using the vehicle windscreen as the guide band the front end to fit - needs to be tuned in 90 degrees but also twisted to take into account the slope of the screen - basically the bottom of the edge of the bar needs to be a few mm longer than the top of the bar.
However I would have thought places like Haflinger Technik would have them
Haflinger 700AP (73)
Range Rover Sport TDV6 (07)
Landrover FC 101 (77)
Landrover Series 1 SWB Station Wagon (57)
Landrover Series 1 SWB (57)
Jaguar E-type Roadster V12 (71)
Jaguar XJ12C (76)
Range Rover Sport TDV6 (07)
Landrover FC 101 (77)
Landrover Series 1 SWB Station Wagon (57)
Landrover Series 1 SWB (57)
Jaguar E-type Roadster V12 (71)
Jaguar XJ12C (76)
Re: Haflinger windscreen supports (pair) needed.
Hi Garry,
Thanks for the photos, very, very useful. I did check out Haflinger Technic but alas they have none.
How is the old ACT? I use to have to go to Canberra quite often to meet various Federal Govt advertising committee members. I lived in Sydney from 1986 until 2009.
Cheers
Thanks for the photos, very, very useful. I did check out Haflinger Technic but alas they have none.
How is the old ACT? I use to have to go to Canberra quite often to meet various Federal Govt advertising committee members. I lived in Sydney from 1986 until 2009.
Cheers
Cheers
Doug Hart
1972 AP 700
Doug Hart
1972 AP 700
- cascade.king
- Posts: 188
- Joined: Sat May 11, 2013 6:54 pm
- Location: Vermont, USA
Re: Haflinger windscreen supports (pair) needed.
Those pics are super! Thanks Garry!
That bend at the "roll bar" end is pretty aggressive. I am planning on (attempting to) make a pair out of EMT (conduit) and see what happens.
That bend at the "roll bar" end is pretty aggressive. I am planning on (attempting to) make a pair out of EMT (conduit) and see what happens.
Mike
1971 North American 700AP Haflinger Pathfinder
1971 North American 700AP Haflinger Pathfinder
Re: Haflinger windscreen supports (pair) needed.
Mike,
My apologies for the delay. I can supply an original pair from a Pathfinder. If interested, please contact me through the NWMF website listed below.
Take care.
Jim Molloy
Waldersee Farm
Sheridan, OR
http://www,northwestmogfest.com
My apologies for the delay. I can supply an original pair from a Pathfinder. If interested, please contact me through the NWMF website listed below.
Take care.
Jim Molloy
Waldersee Farm
Sheridan, OR
http://www,northwestmogfest.com
- cascade.king
- Posts: 188
- Joined: Sat May 11, 2013 6:54 pm
- Location: Vermont, USA
Re: Haflinger windscreen supports (pair) needed.
Hi Jim.
That's great. I'll be in touch as soon as I can..
That's great. I'll be in touch as soon as I can..
Mike
1971 North American 700AP Haflinger Pathfinder
1971 North American 700AP Haflinger Pathfinder